![]() You should now be able to successfully start up and have now solved your unrecoverable error mac issue. NOTE: Be patient while your MacBook restarts. Once you’ve successfully copied the missing file to your MacBook, click the Apple logo at the top left corner and click Restart.If the file does not appear after entering the above command, go back to the TERMINAL section above and try again.With this, TeamViewer should start automatically and close to tray menu. 3) Go back to the General settings and tick Start TeamViewer with Windows back again. 2) Go to the Advanced settings and tick Close to tray menu. Ls /Volumes/Macintosh\ HD/Library/Security/SecurityAgentPlugins/ Hello HexerPsy lilshawn, 1) Go to the General settings (as on your screenshot) and untick Start TeamViewer with Windows. ![]() Now let’s verify the file copied without issue.NOTE: Any error message such as No such file or directory or Read-only file system, means either the source or the destination path or both are not entered correctly. There should be space between bundle /Volumes and again between Macintosh\ HD/ bundle /Volumes It can be difficult to tell where spacing takes place. Now enter the following in the Terminal to copy the missing file from the USB to the Macintosh HD: (Pay close attention to spacing and be aware that the command is case sensitive.)Ĭp -r /Volumes/USB/TeamViewerAuthPlugin.bundle /Volumes/Macintosh\ HD/Library/Security/SecurityAgentPlugins/.NOTE: May take a few minutes for the macOS Utilities window to load. Once complete the macOS Utilities window will appear as seen below.Enter the requested password to continue. You might be prompted to enter the login password of the administrator of your Mac, or your Apple ID password, or a firmware password.NOTE: This process can take some time, so be patient. Restart your MacBook and hold Command (⌘)-R until the Apple logo appears on the screen.NOTE: Exercise patience when entering Recovery Mode. NOTE: Make sure the USB is formatted for the macOS. Copy the TeamViewerAuthPlugin.bundle from /Library/Security/SecurityAgent/ to a USB.Download the needed TeamViewer file TeamViewerAuthPlugin.bundle (if you can’t use the link just provided, try this updated link here ).SecurityAgenet TeamViewer Auth Plugin Unrecoverable Errorįixing the Unrecoverable Error Mac Step 1: Download the Missing File.If you don’t, then go back and read the SSH link in the 2nd paragraph. You need to use the following commands. We’ll assume you’ve already set up SSH and know how to connect. If you’re not at the device and TeamViewer isn’t authenticating, just connect to it with SSH. So, if you’re at the device, just open the terminal. If you’re physically at the computer, why are you using TeamViewer?!? If you’re physically at the computer, you can just restart it with the GUI – or you can use the terminal. It just depends on which terminal, I suppose!Īnyhow, this is just a short article. After all, you might choose to do it locally – where this will also work. Well, no… I have no idea how you’ll be doing it. So, you’re doing it from the terminal – you’re just doing it remotely and using SSH to do that. I actually do this with SSH, but it’ll work in the terminal. The only way to make it work, without visiting the device in person, is to restart it. The reality is, I like TeamViewer quite a bit but it has a nasty habit of failing during the authentication step. In a previous article, I wrote about TeamViewer, and this article will teach you how to restart TeamViewer from the terminal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |